help needed to find cylinder head gasket for a C180 Cummins motor supercharged

hoping someone might be able to help me

looking for cylinder head gasket for a C180 Cummins motor supercharged .

have tried Cummins themselves but no longer make them. have tried copper gaskets in adelaide but they need the old one to make one up but at this stage have not pulled down motor as want to make sure i can get one for it as motor is 69 years old.

am in Adelaide south Australia

Dont waste money with cutout copper gaskets.......they are worse than useless for diesels......Id say the gasket you want would be the C160 one ....ask FleetParts in Toowoomba.

Try ACL, they used to custom make hard to source gaskets.

thanks V8Ian

do you happen to have a number for them please

thanks in advance

Why not make your own?

www.hawleys.com.au/gasket-material-made-...ose-fibers-impregnat

But more practically this mob look to be your answer.
www.njgaskets.com.au/cutting/die-cutting/

It would appear ACL don't do retail, try Repco or www.enginemaster.com.au/ACL

Thanks V8 Ian

Thanks Lang

I thought ACL had closed down.........wasnt that the reason given for stopping Falcon production?......I also went to an auction at Eagle Farm some years ago that was the ACL factory there........There was alot of original Warren and Brown machines there .

.
The C series 160 / 175 / 180 use a steel plate gasget about 2mm thick .........the liners protrude from 004 / 006 thou above the block..........
The head squashes the plate onto the liners and the plate doesent virtually touch the block..............
The oil ways have a neoprane type seal that is part of the head gasget , while the water ways have fibre type square section rings that
are placed into the holes in the plate (head gasket).........
Waste of time making a copper type gasget.................
A couple of blokes in NSW (maybe still on this forum) ........Kirky or Chappo MAY be able to help..................

.....................Billy....................