- Posts: 44
- Thank you received: 0
IH 564 clutch adjustment
6 years 3 months ago #189317
by pcp20us
IH 564 clutch adjustment was created by pcp20us
Hi all, Long time no writing!!
Some may remember a couple of years ago i was fixing up and old 564 inter, doing rear axle seals etc.
Anyway, the guys who tractor it is, they have split it and replaced the pressure plate, the clutch plate was all good according to tractor mechanic, and they machined the flywheel.
Problem is the clutch pedal is not enganging on the fingers of the clutxh plate, even with playing with the adjustment. Theyhave split it again and all seems ok. But still cannot get enough adjustment.
Any ideas on where to from here or is there a simply fix for this. As i had same ussue when i did a clutch on a tea20, that was a simple fix
I am not familar with the 564 clutch setup so will be passing info on.
Thinking they may need to check some spec measurements.
Thanks
Some may remember a couple of years ago i was fixing up and old 564 inter, doing rear axle seals etc.
Anyway, the guys who tractor it is, they have split it and replaced the pressure plate, the clutch plate was all good according to tractor mechanic, and they machined the flywheel.
Problem is the clutch pedal is not enganging on the fingers of the clutxh plate, even with playing with the adjustment. Theyhave split it again and all seems ok. But still cannot get enough adjustment.
Any ideas on where to from here or is there a simply fix for this. As i had same ussue when i did a clutch on a tea20, that was a simple fix
I am not familar with the 564 clutch setup so will be passing info on.
Thinking they may need to check some spec measurements.
Thanks
Please Log in to join the conversation.
Time to create page: 0.392 seconds