steering bump

Hi Fill and all you guys with the suggestions.
I have 1 wedge that I removed from the drivers side and on it is marked front with the number 4 stamped on it, I am now trying to get another wedge for the other side just in case I need to use them.
I now have the manual, I have taken measurements of the axle and springs clearences from the ground and all are near perfect, I will try now all the suggestions that you guys have given me and come back to you all when problem solved.
Thanks again for all your helps.
Kind regards
Russ

new bearings fitted running smooth as.

shocks are new munroes, numbers were crossed referenced by them and you would/nt know it they were the same, will take them off and give it ago without them.
Russ

All look and feel good but will double check.
Russ

Hi Steve,
We live in Elland via south grafton nsw on the far north coast , but currently holidaying in Sydney.
Kind regards
Russ

Russ,
Tad far to drop in for a look.
Cheers Steve, WA

Just noticed the drag link has a bend of about 4-5 mm on end closest to the driver, are these normally bent and if not can I press it back and if not does anyone have one for sale.
Rustyb

Hi Rusty
Just went out and checked mine. The rod is straight as far as I can see. I will have a better look tomorrow in the light. If you buy a new one make sure it is for your truck left or right hand drive. They look almost the same. I got mind from Auto Surplus in Rooks Road Mitcham Vic ph 03 9873 3566 -speak to Bermie and tell him that Phill Quinn with the Bedford said to ring.

Hi Rusty
This is the old one

100_2848 by fill quinn , on Flickr

100_2847 by fill quinn , on Flickr
Hope this helps Cheers Fill

Fill gudday M8

with fixd end ti rod how do u adjust toe in/out

thanx in advance
cya