Re: Commer Q320

Thanks fellas a mate gave me an idea to put a hose from another engines oil preasure switch and screw a fitting in to it with a hose to my engines oil preasure switch hole to get oil through the engine what are your thaughts on this one or if i turn the engine over by hand with fresh oil in it will be enough Thanks Gnennwombat

No..
not a good idea!
The engine will have sufficient pressure and capacity for itself.
If you wind the engine over, with a gallery plug removed, you should see the oil with a minimal amount of turns.
fit a guage if you wish..
Personally, i wouldn't go to a huge expense until you had at least turned it a few revolutions..
If it looks promising, clean the plugs and points
throw a little fuel down the carby and see if it will fire...
Don't run it ..Be satisfied it fired and then go about freshening up some oil etc..
thats my two bobs worth..
chocs

Thanks chocks sounds good