Fruehauf Cattle Cruiser

Bugger me, they must of been dirty overalls Lang
Thats pretty sad, the old 9 inch grinder has been the cause of occasional fire with me
My Dad always had a bath tub full of water out side the workshop door and the odd times he has impressed his leg into it

I have started few grass fires with a 9 inch grinder, always managed to get them out but when on cracking clay soil it takes a while as it burns in the cracks

Paul

I set Fire to a Nylon Jumper I was wearing once with a 9" angle Grinder.. Was a very old one with a Switch & not a Trigger.
Wasn't much Fun holding a Running 9" Grinder in one hand bashing the Flames out with the other hand..

I really miss my 9 inch grinder(the 14 inch not as much) most places have banned anything above 5s these days so the 9 stays at home.

I dont use the 9 inch much anymore since the advent of the cordless 5 inch grinder
But if I have a lot of heavy work there is nothing else as efficient as the 9 inch grinder, mind you after a 15 minutes my hands are all jelly these days


Paul

Hey Mrs. we're all hanging out for the lates episode of the cattle cruiser!
Like a hooker who shows a glimpse of bare flesh and then disappears!
But, if your flat out like a lizard licking we'll have to be patient.
Dave_64

Not that I've looked lately but you could buy the King Gee overalls online.
Important you know the size.

Mrs, any photos of the cattle cruiser in its heyday? Thanks for the videos.

Dave_64 wrote:

Hey Mrs. we're all hanging out for the lates episode of the cattle cruiser!
Like a hooker who shows a glimpse of bare flesh and then disappears!
But, if your flat out like a lizard licking we'll have to be patient.
Dave_64

Dave fear not, got a tad way laid last night

just for your viewing displeasure

Paul

overnite wrote:

Mrs, any photos of the cattle cruiser in its heyday? Thanks for the videos.

Not as yet, as they say there's always more to the story

Paul

Hi AllyPaul interesting how they built rigidity into the trailer Are going to put those small top Hat sections back in between the up rights just asking Notice all the holes in the sheets also have like a flanged for strength. The welding well we will leave that there:unsure: