I.D Plate Etching

Hi everyone, I was hoping someone could help me with a contact to have the plates pictured reproduced-etched? They are for Eaton 2 speed diffs.
Both pics are the same plate, but top one is not legible.
Thanks in advance.
Dean

Hi,
Send Chocs an email, his minister of defence is a wizard for decals, produced one for me for the C Line.
Gilly

Up here there is a mob called Queensland Nameplates, do a lot of that sort of thing for new truck manufacturers as well as the QLD Transport mod plates. They do our towbar rating plates. Not sure about Melbourne, one mob would be Nidderie Nameplates, they do the complience plates for most of Australia, but I'm sure there would be others down there. I might have spelt that wrong.

Ifn U need a print out to stik on from nuther vehicle
th@ looks a bit different
jist clik here
www.hcvc.com.au/forum/YaBB.pl?num=1325908252/2#2

Thank you for the replies peoples, I'll try my luck with Niddrie nameplates as a start.
-D

Just how were these plates fabricated in the first place ??
Was it printing with stencil , and etching ? or a simple offset printing and or etching ?

Now also in Model engineers workshop a while back there was an article where machine mameplates were reproduced by creating a computerf ile of the required image then printing onto wet transfer material etc .. This could be a way to create what you want ..

Good luck richard

If it is etching you need done. Ring Ron at Acme Platemaking 93804498.
About 5 years ago I needed etched name plates for the Fargo,spent days being sent all over Melbourne and they were the only place that could do them.
I would have been smarter to look at my own customer list first because they were on it.
Graham

Ok thanks guys, Graham i'll give them a call.
-D