- Posts: 44
- Thank you received: 12
Chamberlain Fuel system leaking
5 years 5 months ago #197142
by Sanctuary
Chamberlain Fuel system leaking was created by Sanctuary
Please Log in to join the conversation.
Less
More
- Posts: 6821
- Thank you received: 4714
5 years 5 months ago - 5 years 5 months ago #197143
by Mrsmackpaul
Your better to die trying than live on your knees begging
Replied by Mrsmackpaul on topic Chamberlain Fuel system leaking
I think you will find it is just a O ring crook
Will have to lift the, un hook the spring in side (take note of which hole it is hooked to)
Un do the nut on top and slide the do hicky out replace the O ring and re assemble
Or at least thats what I would try
Paul
Will have to lift the, un hook the spring in side (take note of which hole it is hooked to)
Un do the nut on top and slide the do hicky out replace the O ring and re assemble
Or at least thats what I would try
Paul
Your better to die trying than live on your knees begging
Last edit: 5 years 5 months ago by Mrsmackpaul.
The following user(s) said Thank You: Sanctuary
Please Log in to join the conversation.
5 years 5 months ago #197147
by wee-allis
Replied by wee-allis on topic Chamberlain Fuel system leaking
Right info Paul. Just be careful not to drop the little pin and spring which the larger spring hooks to, as it can fall into the pump. You can get a kit from any injection firm which has the "O" rings for both spindles, the fibre washers to go under the top nuts and the gasket. Also make sure you get the Stop lever pin into the slot in the slide, as if you miss it can be impossible to shut the engine down without disconnecting fuel lines.
Not a difficult job, just take your time and observe what you take off and as Paul says, note which hole the pin is in. Steve.
Not a difficult job, just take your time and observe what you take off and as Paul says, note which hole the pin is in. Steve.
The following user(s) said Thank You: Sanctuary
Please Log in to join the conversation.
Time to create page: 0.463 seconds