Updated 28th July.

If you are unable to login, you probably need to read this change to your username & profile.

 

Welcome, Guest
Username: Password: Remember me

TOPIC:

Mobile1's Inter D1510 354 29 Jun 2021 07:09 #222888

  • Mobile 1
  • Mobile 1's Avatar Topic Author
  • Offline
  • Posts: 53
  • Thank you received: 2
Hi all, Recently I purchased a Inter D1510 354 perkins ex victorian country roads board tipper with a hydraulic behind cab crane it is now painted grey hammer finish which covered up its body faults what I can find out the original colour underneath is International school bus yellow, it has had rubbish in the flemming chamber which rusted out the air ducts and rusted the drivers side floor out so problems there ,also it has had two bucket seats fitted by the last owner , can anyone help with a bench seat and the bolt down centre floor panel the gear lever and handbrake come though as one lower side has rusted off, Much Obliged for any help, John.
The following user(s) said Thank You: roKWiz

Please Log in to join the conversation.

Last edit: by hayseed.

Inter D1510 354 29 Jun 2021 09:04 #222893

  • IHScout
  • IHScout's Avatar
  • Offline
  • Posts: 1109
  • Thank you received: 177
G'day mobile 1, if you can't find a better centre floor panel, I would think it would be relatively easy to make up one yourself or patch up the old one. The problem is most Inters will have similar rust problems.
Dennis

Please Log in to join the conversation.

Inter D1510 354 30 Jun 2021 07:23 #222931

  • Mobile 1
  • Mobile 1's Avatar Topic Author
  • Offline
  • Posts: 53
  • Thank you received: 2
Thank for your reply If no luck I may have to have a shot a making it, Regards John.

Please Log in to join the conversation.

Inter D1510 354 30 Jun 2021 14:21 #222941

  • Mobile 1
  • Mobile 1's Avatar Topic Author
  • Offline
  • Posts: 53
  • Thank you received: 2
Hi All, Further to prior post can anyone help with Inter D1510 original bolt on cabin side steps as the previous owner removed them , the further I look the more depressed I get, should have looked harder ,blinded with excitement, Regards John.

Please Log in to join the conversation.

Inter D1510 354 30 Jun 2021 18:14 #222948

  • projectinter
  • projectinter's Avatar
  • Offline
  • Posts: 95
  • Thank you received: 19
The side steps are nearly impossible to remove so they are easy to find.
If you find a wreck I’d say they are still attached but you almost need to cut into the sills to remove them.
They have captive nuts that break and it’s very very awkward to get a spanner into hold the nut once the captive nut spins.

Please Log in to join the conversation.

Inter D1510 354 30 Jun 2021 20:39 #222962

  • Mobile 1
  • Mobile 1's Avatar Topic Author
  • Offline
  • Posts: 53
  • Thank you received: 2
Thank You ProjectInter Much Obliged I will take on board your advice.

Please Log in to join the conversation.

Inter D1510 354 30 Jun 2021 21:29 #222965

  • cobbadog
  • cobbadog's Avatar
  • Offline
  • Posts: 2319
  • Thank you received: 1017
Sounds like a job for one of those 4" round spanners commonly called an angle grinder for easier removal.
Cheers Cobba & Cobbarette
Coopernook, The Centre of our Universe.
STUBBOURN B@ST@RD
The following user(s) said Thank You: Mobile 1

Please Log in to join the conversation.

Last edit: by cobbadog.

Bonnet Hinge - d1510 inter 13 Jul 2021 06:40 #223382

  • Mobile 1
  • Mobile 1's Avatar Topic Author
  • Offline
  • Posts: 53
  • Thank you received: 2
Hi All, Re my recent post looking for d1510 inter steps and seat , I have been lucky and have found both and thank the members for their input, however I neglected to ask if anyone can help with a Drivers side bonnet hinge for the D1510 I am not sure but I think a lot of models may have the same hinges, Regards John.

Please Log in to join the conversation.

Bonnet Hinge - d1510 inter 14 Jul 2021 15:18 #223440

  • JOHN.K.
  • JOHN.K.'s Avatar
  • Offline
  • Posts: 2403
  • Thank you received: 770
All the same ,LH and RH ....trick is finding one that isnt sprung out of shape.......incidentally ,new owners need to realize the hinges need help closing down ,if things are getting cockeyed .......just slamming is a sure way of springing them out of shape.
The following user(s) said Thank You: Mobile 1

Please Log in to join the conversation.

Bonnet Hinge - d1510 inter 14 Jul 2021 20:24 #223456

  • Inter- Action
  • Inter- Action's Avatar
  • Offline
  • Posts: 79
  • Thank you received: 51
Hi there John. If you are not in a hurry i am in the process of wrecking a C1500. Both hinges are in very good working condition.

Please Log in to join the conversation.

Time to create page: 0.431 seconds

Historic Commercial Vehicles Club of Australia Inc.  Post: P.O. Box 2020 Bayswater Vic. 3153    Clubrooms: Unit 8 / 4  Macquarie Place Boronia    Club Phone: 0400 025 525    Club Rooms:  03) 9738 1558