Acco 2350E

Is anyone.wrecking 2350E with C series engine and MT653 auto? I chasing an engine/chassis loom. I have tried all the major to no avail. Would appreciate any leads. Cheers

Location? How bad is the loom you already have?

Thanks for the reply. Loom was thrown out before I purchased the truck. Southern Riverina, NSW.

Had a 2350 bogie new ,and the wiring was the worst mess ever put into a truck.......also had a 1950B and C,and both had similar wiring.........behind the dash was a mass of wires like spaghetti,with inlne plastic case fuses........that wouldnt hold shut after one opening ...........I asked the lektrician to maybe install a new harness ,with a fuse board and plug in fuses .......never done.....he must have taken one look at the mess ,and said ...Naaaaa........want to know which inter had the best wiring......the army ACCOs ,three pieces ,joined by screwup Cannon connectors,proper swithch board with mostly circuit breakers that automatically reset ,and brass toggle switches ......the 1950s and 2350s had those awful rocker switches and lights that popped out and landed in the dirt on the floor ...just as you were demonstrating the indicators and wipers for the transport .......And the wipers......fit air wipers if you dont want to have to stop when its wet.

Did you Try Cowra Trucker Wreckers??

They Specialise in Wrecking IH stuff...

id be getting a new one made up......no point even fitting an old brittle harness ,unless you already have it in the shed,and need to save .

Yes, certainly did but no good. Just going to get an auto elec to make it from scratch.