New member old white

Hello to you all. I have purchased a White Road Commander SE9 and was keen to learn about the history of the truck. By reading this forum there is a few people that share my interest about this mark.It has a 892 tta,13 speed with 6 rod suspension. Good for 75 ton.Model number TE3704 RCS64 Motor number 8vf045802. Maybe a Smith's at Williamstown? Cheers Will try to post a photo.

Conrad, welcome aboard, get ya self a photo bucket account and check our FAQ for how to post a Picture...... we lurve ........pictures, and old whites are high on the list of loving.

/me

conrad gudday from nth QLD to nth QLD as sarge says set up the photo bucket thingo account all free of charge bung up a piccy seeya
Paul

P1010948_zps476bP1010947_zpsa07accac.jpg8aff.jpg photo by cmepl3P1010946_zP1010945_zps0e6088e5.jpgpsc5d9b598.jpg Don't know if this worked.

i932.photobucket.com/albums/ad170/cmepl3...0948_zpsddb6d0a0.jpg Lets try this.

That does sorta work. It goes like this:

[img] address of your pic goes here[/img]

Anyway, nice truck! It's good to see the less common makes getting some attention.

Cheers, ASW.

I'll try again. :-[
(img]address of your pic goes here[/img)

Replace curved brackets ( ) with square [ ]
(if I show it with all square, it comes up blank)

It can be found in the FAQ section. Hardly anyone gets it first time

Cheers, ASW.

Hey Conrad very nice rig welcome to the forum as a new member myself I find this an invaluable source of information from the forums very helpfully members regards Bryant

Nice one Conrad.Ive just figured out this photobucket stuff my self, well partially anyway....U MITE SAY.....Billy

You are both very close and fantastic that you have had a try at it.

When in photobucket move mouse over the small picture and a sprocket appears in the top right corner move the mouse over it and another box drops down move and click on get links then click on the "IMG" link "bottom one and it will show copied. Then just click in your post on here where you want the photo then right click on the mouse and click paste. To make sure you have done it properly click on preview first you can then see how it will come up on the forum. Remember to save after previewing if all is ok.

Trevor